5-1
Chapter 5
Viewing and Printing Saved Reports
Chapter 5 provides the following information:
• Instructions for sending saved test reports to a serial printer.
• Instructions for editing the report identification information.
• Instructions for viewing, deleting, and renaming test reports saved in the test
tool’s memory.
Printing Test Reports
This section describes how to send reports directly to a printer. If you want to send
reports to a computer, use the DSP-LINK software provided with the test tool. See
Appendix A for instructions on running DSP-LINK.
The PRINT mode on the rotary switch allows you to send saved Autotest reports
or report summaries to a serial printer or a PC through the test tool’s EIA-232C
serial port. You can also edit the header, operator name, and site name that appear
at the top of reports. Examples of printed Autotest reports are shown in “The
Autotest Report” in Chapter 3.
To Next Page
Loading...
