DSP-100/2000
Users Manual
3-24
2
4
3
5
1
gc15c.eps
Figure 3-8. Screen for Saving Autotest Results
Table 3-10. Items on the Autotest Save Screen
Item Description
1
The characters you can use to make a name for the test results you are saving.
2
The date and time when the Autotest was saved.
3
The default name assigned to the results from the most recently completed test.
4
Softkey for moving the cursor to edit characters in the middle of the cable
identification. On Model DSP-100 with software versions 3.0 and earlier, use the
@ ³ softkey to move the cursor back to the right. On Model DSP-2000, press
! Â until the cursor wraps back to the right.
5
The remaining number of locations available for storing Autotest results.
To Next Page
Loading...
