1AC II Custom Instruction Sheet
Page 2
Operating/Storage Temperature: -10 °C to 50 °C
Operating Relative Humidity:
0 % to 95 % ............ 0 °C to 30 °C
0 % to 75 % ............ 30 °C to 40 °C
0 % to 45 % ............ 40 °C to 50 °C
Altitude: 3000 m
Symbols
Consult user documentation.
WARNING. HAZARDOUS VOLTAGE. Risk of electric shock.
This product complies with the WEEE Directive marking requirements. The
affixed label indicates that you must not discard this electrical/electronic product
in domestic household waste. Product Category: With reference to the
equipment types in the WEEE Directive Annex I, this product is classed as
category 9 "Monitoring and Control Instrumentation" product. Do not dispose of
this product as unsorted municipal waste.
Measurement Category IV is applicable to test and measuring circuits
connected at the source of the building’s low-voltage MAINS installation.
Operating Instructions
Power On
Momentarily push . Listen for a double beep to confirm activation. A continual VoltBeat flash
visually indicates the Tester is active.
Power Off
Press and hold for more than half a second. Listen for a long half-second beep to confirm
deactivation of the Tester. The absence of the VoltBeat flash indicates the Tester is inactive.
VoltBeat (System Self-Test)
VoltBeat is a self-test feature for visual confirmation of battery and system integrity, and power
on. It provides a double-flash every two seconds during normal operation.
Check for the Presence of AC Voltage
Placing the tip of the unit near an ac voltage produces a steady glow at the tip and, if enabled,
a continual beep.
Auto Power Off
After about five minutes of non-use, the Tester automatically powers off to save battery life. A
double beep, followed by a longer, single beep, provides audible indication that the Tester has
powered off. The absence of the VoltBeat flash serves as a visual power-off indication.
Disabling the Beeper
Disable the beeper by holding the green button down for more than two seconds during power
up. To enable the beeper again, turn the Tester off, and then turn it on.
Low Battery Indication
When the battery voltage drops below two volts, VoltBeat provides visual indication by
stopping the VoltBeat flash. Replace with two AAA (LR3) batteries.
Cleaning
Clean with damp cloth.
Contact Fluke
Fluke Corporation operates worldwide. For local contact information, go to our website:
www.fluke.com
To register your product, view, print, or download the latest manual or manual supplement, go
to our website.
Fluke Corporation Fluke Europe B.V.
P.O. Box 9090 P.O. Box 1186
Everett, WA 98206-9090 5602 BD Eindhoven
+1-425-446-5500 The Netherlands
fluke-info@fluke.com
LIMITED WARRANTY AND LIMITATION OF LIABILITY
This Fluke product will be free from defects in material and workmanship for two years from
the date of purchase. This warranty does not cover fuses, disposable batteries, or damage
from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation
or handling. Resellers are not authorized to extend any other warranty on Fluke’s behalf. To
obtain service during the warranty period, contact your nearest Fluke authorized service center
to obtain return authorization information, then send the product to that Service Center with a
description of the problem.
THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH AS
FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR IMPLIED. FLUKE IS NOT
LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES
OR LOSSES, ARISING FROM ANY CAUSE OR THEORY. Since some states or countries do
not allow the exclusion or limitation of an implied warranty or of incidental or consequential
damages, this limitation of liability may not apply to you.
11/99
To Previous Page
Loading...
Need help?
General
