9
GETTING STARTED
First Call
. Enter the area code and the phone number and press Calling Key.
Tip: Before you get started, you must insert a valid SIM card in your phone and
charge the battery.
SIM Card: Please refer to “Inserting a SIM Card” for more reference on
installation.
Charging the battery: Please refer to “Battery and Charging” for more details.
Inserting a SIM Card
Your mobile phone number, PIN (Personal Identification Number), PIN2, PUK
(Personal Unlock Key), PUK2 (Personal Unlock Key2), IMSI (International Mobile
Subscriber Identity), the network information, the phonebook data, SMS (short
messages) and other data are stored in your SIM card.
Note: This particular phone model only supports the SIM cards of 1.8V and 3V.
Some network operators don’t offer PIN2 and PUK2, so functions using these
passwords will be unavailable.
The SIM card and its contacts can be damaged by scratches or bend easily, so
be careful while handling, inserting or removing the card.
Keep all SIM cards out of children’s reach.
Note: Always make sure the phone is switched off before you insert or remove the
SIM card, otherwise it may damage the SIM card.
Mounting
1. Remove the battery cover.
2. Insert the SIM card, with the notch at the top left and the gold contacts face down,
into the card slot. Align the card to the arrow sign as shown below.
3. Replace the battery and close the cover tightly.
Note:
If the SIM Card is installed improperly or damaged, the prompt words “Insert SIM”
will display on the screen after you switch ON your phone. Remove the SIM Card
and then mount it again as displayed.
To Next Page
Loading...
