FLY SX260 - Inserting a Memory Card

10
 If “Insert SIM” still appears on the screen after you have inserted the SIM
correctly, there may be something wrong with your SIM card. Please contact your
network service provider for assistance.
 If the screen displays that the SIM card is locked permanently, please consult
your network service provider.
Inserting a Memory Card
Open the cap from the Hinge Type Connector. Lay the T-Flash card with the gold
contact facing down on the Connector and then close it. Align the card to the arrow
sign as shown in the picture:
Charging the Device
.
1. Plug the connector of the travel adapter into the phone.
2. Plug the travel adapter into a standard AC wall outlet to start charging.
3. When your phone indicates that the battery is fully charged, please pull the
travel adapter out from the I/O socket of the phone.
Note: 1. If the battery is totally empty or not enough, it may take a few minutes
before the charging indicator appears on the screen.
2. Always keep your phone connector and charger dry.
Warning: Make sure that the standard voltage/power of the place where you
charge the battery matches with the rated voltage/power of our travel adapter.
Switching Your Phone On/Off
Press and hold Power Key for a few seconds to switch your phone on.
 If the phone ask’s for a phone lock code:
Enter the phone lock code, and press OK.
 If the phone ask’s for a PIN code:
Enter the PIN code, and press OK. The PIN code is usually supplied with the SIM
card. Please consult your network operator for more information.
 Access the standby mode.
Press and hold Power Key for a few seconds to switch your phone off.