USER INSTRUCTIONS
BEFORE USE
• Remove the two screws from the seat cover and lift out the cover.
• Connect the battery terminal. You must connect the same color wires together: black
connector to the black terminal, red terminal to the red connector. Make sure they are
connected with the correct polarity.
• Replace the seat cover with the two screws and tighten.
CHARGING THE BATTERY
• Plug the charger into a standard 120v wall outlet and the
wire end into the charger port.
• Fully charge the battery for 8-12 hours.
• Do not charge the battery for more than 12 hours.
• Check the battery and charger for any signs of wear or damage
before use and do not use if damaged.
OPERATING THE VEHICLE
• Press the power switch down or up to turn the vehicle on. Note, down position (-) is
low speed. Upward postion (=) is high speed.
• Bumper car is equiped with slow start function for safety. When starting out bumper
car will take 4 seconds to get up to full speed.
• Push or pull the control joysticks to move the vehicle
• Release both control joysticks to stop the vehicle completely
WARNING: Close supervision is required when child is operating the vehicle.
Power On/O/Speed switch
High-speed
Low Speed
Charging
port
O
Flybar_V1_12V_Bumper_car_manual_Costco_USA.indd 5Flybar_V1_12V_Bumper_car_manual_Costco_USA.indd 5 7/13/23 10:35 AM7/13/23 10:35 AM
To Next Page
Loading...
