PROBLEM POSSIBLE REASON SOLUTION
Vehicle needs a push
to go forward
Poor wire connection
Check if the battery
connectors are rmly con-
nected. Contact customer
service if necessary
“Dead spot” on motor Contact customer service
Loud grinding sound or
clicking sound fro the
motor or gear box
Damaged motor or
gear box
Contact customer service
Battery does not charge
Disconnected / badly
connected charger
Reconnect the battery
Disconnected / badly
connected charger
Make sure the charger
is rmly plugged into the
power source and
connected to the
charging port
Charger not working Contact customer service
Charger feels warm with
charging
Normal
FCC INFORMATION
WARNING
Any changes or modications to this unit not expressly approved by the party respon-
sible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with instructions may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Flybar_V1_12V_Bumper_car_manual_Costco_USA.indd 8Flybar_V1_12V_Bumper_car_manual_Costco_USA.indd 8 7/13/23 10:35 AM7/13/23 10:35 AM
To Next Page
Loading...
