Charging your Jump Starter
1. Please use the provided micro usb cable to charge the product.
2. While charging the Jump Starter, the LED light will be flashed. Once it is fully charged, all 4 LED lights will on.
3. Note: Before using the product for the first time, please charge the portable jump starter for at least 7 hours .
Charging your iPhone, Smart Phones or any other Devices
Press the switch to charge your iPhone, Smart Phones or any other Devices. Unplug the cable when no charge is
required.
LED Mode
Press ON/OFF Button for 3 seconds to turn on the LED light. In the light mode, press button shortly for exchanging
modes among illumination, SOS, flash light and turn off.
Start your Car
Getting Started
1.Insert the plug of the smart clip completely into the jump starter, the red and green lights flicker alternately.
2.Correctly clip the red and black clamps to the electrodes of the car battery (red to positive and black to negative).
3.Start the vehicle.
4.When the vehicle is started, remove the jumper cable from the vehicle battery.
English
01 02 03 04
05 06 07 08 09 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30 31 32
33 34 35 36 37 38 39
40 41
To Next Page
Loading...
