Flymo Hover Vac User Manual

Adjusting the Cutting Height
• THERE ARE 2 CUTTING HEIGHTS (F & G)
• Height of cut is adjusted by turning over the
cutting head.
• Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating.
Turn your product upside down.
• To Remove the Cutting Head and Fan (H)
Hold the fan firmly and twist the cutting head anti-
clockwise as illustrated. Hold the cutting head in
the centre and remove as illustrated. Hold fan in
the centre and remove as illustrated.
• Inspect for damage and clean as necessary before
replacing the fan and the cutting head.
• To Refit the Fan and the Cutting Head (J)
Replace the fan as illustrated. Replace the cutting
head, adjusting the height of cut as required. Hold
the fan firmly and twist the cutting head clockwise,
as illustrated.
• IMPORTANT
ENSURE FAN AND CUTTING HEAD ARE COR-
RECTLY LOCATED
H
J
1
2
3
3
2
1
HIGHEST
This symbol visible
LOWEST
This symbol visible
F
G
4

Flymo Hover Vac Specifications

General

Power	1400 W
Cutting Width	30 cm
Grass Box Capacity	30 L
Cable Length	10 m
Weight	6.5 kg
Power Source	Electric
Grass Collection Capacity	30 L