V
Maintenance
T
S
• WARNING
Disconnect from the mains electricity supply, before at-
tempting any maintenance or adjustment. Cutting
head continues to rotate after the trimmer has been
switched off. Keep fingers and hands clear of the line
cutter on leading edge of guard.
Caring for your Contour
After you have finished using your Flymo Contour follow
the procedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning fluids, or
solvents, just remove debris with a suitable tool, a soft
brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (Fig S) and the motor
housing air vents. (Fig T)
4. Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with a
soft brush (V & W).
5. Attach wheel as described in Wheel Assembly.
6. Inspect the trimmer carefully, especially the parts of
the cutting head.
7. If your trimmer is damaged in any way contact your
local Husqvarna UK Ltd. approved service centre.
• Never use a damaged trimmer.
Cable Storage
1. Your mains cable can be stored on the product as illus-
trated in Fig X1.
2. Wind cable carefully to avoid kinking.
• Store in a cool, dry place and out of reach of children.
Do not store outdoors.
X
W
To Next Page
Loading...
Need help?
General