How to Trim
WARNING: The use of eye protection is recommended.
Do not lean over the trimmer guard whilst trimming, objects
may be thrown by the cutting line. Do not allow cutting head
to rest on the ground. Do not overload your trimmer. Over-
loading can be avoided by making sure the motor speed
does not drop unduly. Disconnect the mains electricity sup-
ply before attempting any maintenance or adjustment.
1. Cut with cutting line at an angle using the tip (G).
2. Swing trimmer in and out of the cutting area taking
small cuts (G).
G
To feed the nylon line
1. Press and hold the two latches (H).
2. Gently pull the line until it reaches the line cutter.
3. Release the two latches. Check that the spool is
locked in position.
4. If too much line has been fed out, press the two
latches and turn the spool anti-clockwise until the line
is at the desired length.
To r e move spool
1. Press and hold the two latches.
2. Pull spool out of spoolholder (J).
When refitting the spool
1. Keep all areas of the spool and spoolholder clean.
Failure to do so may prevent the spool from being se-
curely located in the spoolholder.
2. Make sure the line is placed through the slot in the
spoolholder (K).
3. Place spool into spoolholder and press down into place.
4. Check that the spool is correctly fitted by trying to
re-
move the spool without depressing the latches (K1).
To r e place nylon line
Replacement line is available from most Husqvarna UK
Ltd. stockists. You can buy it either as spool and line
complete or as nylon line only.
To r e place spool and line complete
1. Remove old spool.
2. Release line from cleat. Unwind approximately 100mm
of line and feed through slot in spoolholder (K).
3. Re-fit spool into spoolholder. Check that the spool is
locked in position.
To r e place nylon line on spool
1. Take approximately 5 metres of line line and insert
into one of the line lock holes in the spool (L).
2. Wind line onto spool in the direction of the arrows on
the top of the spool. Care should be taken to ensure
that the line is neatly coiled on the spool (L).
3. Leave approximately 100mm of line unwound and
feed through slot in spoolholder (K).
4. Replace spool into spoolholder.
Ensure spool is correctly fitted.
Remember! Your trimmer is designed to use only nylon line
with a maximum diameter of 1.5mm
. Use only genuine
Husqvarna UK Ltd. nylon line.
Manual Line Feed System
Line cutter
Spool
Spoolholder
Latches
Slot
H
J
K
Cleat
K1
To Next Page
Loading...
Need help?
General