L
Line lock
hole
Fault Finding Hints
WARNING! Disconnect from the mains electricity supply be-
fore attempting any maintenance or adjustment.
1. Line too short.
Feed out line.
2. Line broken inside of spoolholder.
Remove spool and re-thread line.
3. Line jammed on spool.
Remove spool and rewind line to remove crossed loops.
4. Poor performance.
Ensure the inside of the spoolholder is clean and free
from debris.
5. Line snaps continuously.
Use only tip of nylon line to trim. If symptoms still per-
sist, change spool and line.
6. Line will not pull out.
Check that line has been released from cleat.
7. IF FAULT PERSISTS
Contact Husqvarna UK Ltd. Customer Service. Tele-
phone 0844 844 4558.
Automatic Line Feed System
How the automatic line feed works (M)
1. When initially switching on the trimmer, a small length of
line is fed out.
2. A ‘clattering’ noise will be heard when the nylon line hits
the line cutter. DO NOT BE ALARMED this is quite nor-
mal. After approximately 5 seconds the line will be cut to
the correct length and the noise will reduce as the motor
reaches full speed.
• Make sure the motor is up to full speed before trimming.
3. If the noise of the nylon line being cut cannot be heard,
more line will need to be fed out.
4. To feed more line, it is first necessary to to allow the
motor to stop completely, then re-start, allowing the
motor to reach full speed.
5. Repeat step 4. until you hear the line hitting against the cutter.
(Do not repeat this procedure more than 6 times)
6. If problems are experienced with the automatic line feed
refer to Fault Finding Chart.
To manually feed the nylon line (N)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed button,
whilst gently pulling on one of the lines until the line
reaches the line cutter.
3. When the required amount of line is fed out, gently pull
on the second line (there is no need to press the manual
line feed button again).
4. If the line extends past the line cutter, too much line has
been fed out.
5. If too much line is fed out, remove the spool cap and click
spool anti-clockwise until the line is at the desired length.
To r e move spool cap
1. Press and hold in the two cap release latches. (P).
2. Pull
cap away from the spoolholder. (P).
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean. Failure
to do so may prevent the cap being securely located in
the spoolholder.
2. Replace the cap, pressing firmly DOWN
towards the
spoolholder to ensure cap is fully located.
3. Check that the cap is correctly fitted by trying to remove
it without depressing the two latches.
To r e place nylon line.
For your convenience it is recommended you buy spool and
line complete. Nylon line only is also available. Both are
available from Husqvarna UK Ltd. stockists.
Line cutter
Manual line
feed button
Cap
Cap release
latch
Spool
Spoolholder
Eyelet
M
N
P
To Next Page
Loading...
Need help?
General