9
J
13
For ext r a suppor t when using your
product as a vacuum, a shoulder strap
isincluded.Attachthestraptothe
blower uni t before operation. Snap the
hook onto the retainer as illu strated in
figure J.
Converting from Vacuum Use to Blower Use
L
WARNING: Switch off the pr oduct
and disconnect fr om the mains electri cit y
supply before opening the inlet cover or
att empti ng to install or remove the
blower tube or vacuum tubes. The motor
must be stopped and the impeller
blades no longer turning to avoid serious
injury from the rotating blades.
1. S witch of f the prod uct and dis con-
nect fro m the mai ns electr i city supply.
2. Remove the elbow tube and debris
bag as illus trated in figure K.
3. Remove the vacuum tubes by re-
leasing the lat ch on the vacuum inlet
cover and rotatin g the cover until the
tu be s are released from the latches
on the retaining posts as illustrated in
figur e L.
4. Close the inlet cover and make
sure it is latched c losed.
5. Re-install the blower tube. Refer to
BLOWER ASSEMBLY for instructions
on how to attach this item.
To Next Page
Loading...
