Need help?Do you have a question about the FlySky Noble Pro and is the answer not in the manual?
General| Frequency | 2.4GHz |
|---|---|
| 2.4GHz Protocol | AFHDS 3 |
| Online Update | Yes |
| Telemetry | Yes |
| RF Power | 20 dBm |
| Antenna | External |
| Data Output | SBUS, PPM |
| Temperature Range | -10°C to 60°C |
| Humidity Range | 20%-95% |
| Display | Color LCD |
| Charging Port | USB-C |
| Compatible Receivers | FlySky AFHDS 3 receivers |
| Model Memory | 30 |
| RF Band | 2.4GHz |
Symbols indicating danger, warning, or attention with their meanings and potential consequences.
Guidelines for safe operation, including prohibitions and mandatory actions for safe use.
Overview of AFHDS3 system advantages, including bidirectional data, RF configuration, and low power consumption.
Detailed diagram and labeling of the Noble Pro transmitter components and features.
Instructions and safety precautions for installing and attaching the transmitter battery pack.
Step-by-step guide for powering on the transmitter and connecting the receiver.
Procedure for binding the transmitter and receiver, including AFHDS3 two-way/one-way specifics.
Steps for safely powering off the transmitter and receiver, including a critical safety warning.
Adjusting steering channel response curve via Rate and Exponential settings for better control.
Adjusting throttle channel response curve via Rate and Exponential settings for acceleration control.
Assigning physical buttons/knobs to control functions or auxiliary channels for quick access.
Setting steering, forward, brake, and response speeds for various channels to optimize vehicle handling.
Setting up mixing functions like 4WS, Track, Drive, Brake, and Programming Mixes for advanced control.
Auto braking system to prevent wheel lock, managing brake pressure by pumping.
Accesses gyroscope functions for vehicles with gyroscopes, including calibration.
Adjusts transmitter to bind state for pairing with receivers, supporting dual-receiver mode.
Sets receiver output mode (PWM, PPM, i-BUS, S.BUS) for different receivers and ports.
Configures failsafe settings for channels to maintain last position or move to a set position upon signal loss.
Monitors receiver battery voltage and sets low/high voltage alarms for timely alerts.
Updates receiver firmware via USB and 'Flysky Assistant' for optimal performance.
Calibrating trigger and wheel center and outer positions for accurate control.
Updating transmitter firmware using USB and computer software.
Resetting all transmitter settings and functions to their original factory defaults.
To Next Page
