What to do if FlySky Remote Control motor won't start and red LED flashes?
If the FlySky remote control motor doesn't start and the red LED flashes quickly after powering on, the throttle channel of the radio might be shifted or changed. Adjust the throttle channel of the radio to match the existing neutral point until the red light stops flashing.
How to fix FlySky Remote Control when motor won't start and indicator light is off?
If the motor doesn't start and the indicator light is off after powering on your FlySky remote control, it could be that the ESC has no working voltage. Check the connection between the battery and ESC for any issues, and inspect the relevant plug for faulty welding. If the ESC switch or the ESC itself is damaged, return it to the factory for inspection.
What to do if FlySky Remote Control motor suddenly stops rotating?
If the motor suddenly stops during rotation, it could be due to a lost throttle signal. Check the radio and receiver. Alternatively, the ESC might be in low voltage or overheat protection mode, indicated by a flashing red light. In this case, examine the battery voltage and ESC temperature.
Why FlySky Remote Control car goes in reverse when I push forward?
If your car reverses when you push forward on the FlySky remote, it could be due to the connection sequence between the ESC output line and the motor line. Try exchanging the position of two motor lines. Another possibility is that the throttle direction on the radio is set incorrectly; set the throttle direction to the opposite direction.
What to do if FlySky Remote Control motor accelerates rapidly and then stops?
If the motor accelerates rapidly when it starts and then stops, it may be due to insufficient battery discharge capacity. Try replacing the battery with one that has a stronger discharge capacity. It could also be that the motor's rotation speed is too high, and the gear ratio is not reasonable. In this case, replace the motor with a low-speed motor or increase the reduction ratio.
General| Brand | FlySky |
|---|---|
| Model | HRZ00015 |
| Category | Remote Control |
| Language | English |
Explains hazard symbols like Danger, Warning, and Attention.
Provides mandatory and prohibited actions for safe product operation.
Steps for safely turning on and off the transmitter and receiver.
Procedure to set the neutral position for steering wheel and throttle trigger.
To Next Page
