FMC Technologies INVALCO 64908265 - Magnetic Pickup Options; Available Pickup Models and Specs

6
Issue/Rev. 0.6 (2/06)
Standard Magnetic Pickup
Stock No. 64908265
Temp. Range: -65° to 225°F
Coil Resistance: 975 OHMS
Coil Inductance: 400 mH
Housing: Stainless Steel
Mating Connector: 10SL-4S
Extended Temperature
Magnetic Pickup
Stock No. 64919755
Temp. Range: -450° to 450°F
Hermetically Sealed
Coil Resistance: 975 OHMS
Coil Inductance: 400 mH
Housing: Stainless Steel
Mating Connector: 10SL-4S
Wire Lead
Magnetic Pickup Kit
Stock No. 49020839
Use with all meter mounted readout
devices.
Temp. Range: -65° to 225°F
Coil Resistance: 975 OHMS
Coil Inductance: 400 mH
Housing: Stainless Steel
Signal Connection: 7” Wire Leads
Low Drag
Magnetic PIckup
Stock No. 64920774
For special applications
Temp. Range: -65° to 225°F
Coil Resistance: 975 OHMS
Coil Inductance: 400 mH
Housing: Stainless Steel
Mating Connector: 10SL-4S
NEMA 6 Watertight
Magnetic Pickup
Stock No. 64920920
Molded 15’ thermo-plastic rubber
cable and connector, ozone and
ultraviolet resistant, excellent heat
aging/abrasion resistance. Suit-
able for outdoor applications and
installations that require hose
down cleaning of meter.
Temp. Range: -65° to 225°F
Housing: Stainless Steel
Pre-Amp Magnetic
Pickup Kit
Stock No. 49016811
Temp. Range: -40° to 180°F
Housing: Stainless Steel
Output: Square Wave
Supply Voltage: 5 to 26 VDC
Output Impedence: 2.2K OHMS
Load Current: 15mA (NOM)
Output Voltage: 90% Supply
Mating Connector: 10SL-3P
RF (Radio Frequency) Pickup Kit
Non Magnetic
Stock No. 49020795
Temp. Range: -40° to 212°F Continuous
250F Intermittant
Housing: Plastic
Output: Square Wave
Supply Voltage: 5-26 VDC
Load Current: 20mA (NOM)
Output Voltage: 5 VDC Regulated
Mating Connector: 10 SL-3P
This pickup must be used with the 1/2” Turbine Meter to
achieve stated accuracy over the 10:1 range of the meter.
Special Extended High Temp. Magnetic Pickup
Stock No. 64917721
Temp. Range: -450° to 800°F Continuous
+1000°F Intermittent
Housing: Stainless Steel
Supplied with 3’ Stainless Steel Shielded Overbraid Cable
with connector
Mating Connector: 10 SL-4P
Requires Turbine Flow Meter Modification.
Not Pictured
Magnetic Pickups