Issue/Rev. 0.0 (2/10)
MNFG003 • Page 11
Section IV – Program Mode
Changing Program Mode Parameters
The program codes represent parameters that can be changed either to enhance the performance of the
microFlow.net Gas or to accommodate application changes. There are three types of parameters in microFlow.net Gas:
codes that require numerical data, codes where an option can be selected from a list, and codes where
alphanumeric data is entered. Once a code has been selected, change the programmed contents by entering a new
value through the keypad.
Numeric Data
The numeric data is entered into the program codes via the keypad just as numbers are entered into a calculator.
Alphanumeric Data
The parameters that require alphanumeric data are the codes that display Product Messages, Prompt Messages,
or Permissive Messages on the displays of microFlow.net Gas, or provide information to be printed out on the Bill of
Lading Emulation. When adding or changing information in these alphanumeric program codes, the keys listed below
perform the following functions:
KEY DESCRIPTION
ENTER Moves the character from the character set to the ID line. Also enters the data into the
instrument’s memory after END has been selected from the character set.
SET Moves the cursor six positions to the right.
g Moves the cursor one position to the right each time it is pressed.
f Moves the cursor one position to the left each time it is pressed.
h andi Selects the next block of characters. An example of this is changing from uppercase
letters to lowercase letters.
The blocks of characters available in microFlow.net Gas are as follows:
• A B C D E F G H I J K L M N O P Q R S T U V W X Y Z # *
• a b c d e f g h i j k l m n o p q r s t u v w x y z & @
• 0 1 2 3 4 5 6 7 8 9 < > ( ) ? ! . , ' - " / + = _ END
To Next Page
Loading...