Every transmitter is calibrated before leaving the factory, however if recalibration is required,please follow
these steps:
1.Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way forward,then turn on the
transmitter in calibration mode.
The R.LED and G.LED will flash twice.
2.Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
When calibration is completed the R.LED will be off.
3.Trigger calibration: Pull the trigger back then forward as far as it will go.
When calibration is completed the G.LED will be off.
4.Once calibration is complete press the bind key to save and exit.
Follow the steps below to turn off the system:
1.Disconnect the receiver power.
2.Toggle the transmitter's power switch to the off position.
请按照以下步骤进行关机:
1.断开接收机电源。
2.将开关拨到[OFF]位置，使发射机关闭。
发射机在出厂前已校准完成，如需要重新校准，请按照以下步骤执行：
1. 同步将手轮顺时针打到最大、扳机往前推到底并开机，进入校准模式功能；
R.LED 和 G.LED 二闪一灭
2. 手轮校准：操作手轮顺时针和逆时针转到最大最小；
R.LED 灭
3. 扳机校准：往前往后推到最大最小；
G.LED 灭
4.校准完成后按“BIND” 键退出并保存数据。
4.Power OFF
关机
3.Stick Calibration(This function is used to set the neutral position for throttle and wheel)
遥感校准（该功能可以用于方向手轮和油门扳机的中位角度修正。）
Danger
危险
Make sure to disconnect the receiver power before turning off the transmitter. Failure to do
so may lead to damage or serious injury.
关闭时，请务必先关闭接收机电源，再关闭发射机，否则可能导致模型损坏、人员受伤。
Instructions
操作指引
9
To Next Page
Loading...
