Transmitter Overview
Introduction
Looking for a mini scaler that's dependable, detailed and confident on any terrain?
Introducing the Toyota LC80 Land Cruiser.
From the period-correct lights and functioning indicators to vents on the vehicle body, the Land Cruiser was
designed to static-model standards. Even the interior is painstakingly recreated in 1:18 scale.
A feature-packed trail-proven chassis drives the Land Cruiser. Aluminum rails provide a rigid platform while a
multilink geometry with panhard bar chassis design allows for maximum axle articulation.
Power is delivered from the super high-torque gearbox to ultra grippy beadlock tires via nylon driveshafts.
Water-resistant 2S 7.4V electronics consists of an independent servo, 2-in-1 receiver/ESC, 050 motor and 7.4V
380mAh battery; Allowing for high power-to-weight ratio and all weather operations.
If you want the best looking, best performing 1:18 scaler on the market, look no further than the Land Cruiser
LC80!
[1]
Traversing handwheel, 35 degrees on
each side（CH1）
[10] ST.D/R
[2]
Throttle button, 25 degrees in front and
12.5 degrees at rear（CH2）
[11] TH.D/R
[3]
Push button switch (CH4) [Push button
[12] Switch to the electric adjustment mode
[4] Three-position toggle switch（CH3） [13] TH.REV
[5] Lanyard hole [14] G.LED
[6] Handle, 4*AAA battery compartment [15] BIND
[7] ST.REV [16] ST.TRIM
[8] R.LED [17] TH.TRIM
[9] RX.BATT [18] Power Switch
01
EN
To Next Page
Loading...
