Failsafe
This function dictates what the receiver will do in the event that it loses signal from the transmitter, this includes servo
position etc.
Dial Switch sign
Beginner Mode
ESC Parameter Setting
Beginner mode is designed for people new to the hobby.
In this mode the throttle will be limited to 50 percent, The channel range defaults to 1250~1500~1750 us.
Setup:
To switch between beginner and normal modes press and hold the channel 4 button as the transmitter is turned on.
Note: By default, the system is set to normal mode. The GLED will flash slowly for 3 seconds during power on if the
system is set to beginner mode.
The Dial Switch on the transmitter is used to set ESC parameters, that is, the Dial Switch is located at different
positions and the corresponding parameter values are different.
Setting Method:
There are three parameters can be set for the ESC, which are "Running mode", "Battery type", "Drag brake", There
are slide switches numbered 1 2 3 4 on the radio panel . The above parameters can be set by dialing down and up.
The specific operation is as follows:
When No. 1 slide switch is on the down, it indicates that the operation mode is set to FWD / REV / BRK.
When No. 1 slide switch is on the up, it indicates that the operation mode is set to FWD/REV.
When No. 2 slide switch is on the down, it indicates that the battery type is set to Lipo.
When No. 2 slide switch is on the up, it indicates that the battery type is set to NiMH.
When No. 3 and No.4 slide switch are on the down, it indicates that the drag brake force is set to 0%.
When No. 3 slide switch is on the down and No.4 slide switch is on the up, it indicates that the drag brake force is set
to 50%.
When No. 3 slide switch is on the up and No.4 slide switch is on the down, it indicates that the drag brake force is set
to 75%.
When No. 3 and No.4 slide switch are on the up, it indicates that the drag brake force is set to 100%
When the transmitter is switched on in normal communication state, keep the channel to be set at the position of the
failsafe setup, and press and hold the BIND button for 3S. The G.LED flashes for 2S, indicating that the setting is
successful. That is, when the receiver cannot receive the signal, it will output the set failsafe value.
Note: The fail-safe function has no default set at the factory and as such must be set manually. If no failsafe setting
has been set, then the receiver will not output anything when signal is lost.
Setup:
06
EN
To Next Page
Loading...
