12
Getting Started
使用前准备
Receiver and Servo Installation
接收机与舵机安装
Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
• For safety always power on the transmitter before the receiver.
Make sure that the receiver is mounted in an appropriate location within the model, to ensure a stable
signal, maximum range and to mitigate external interference, follow these guidelines:
Pay attention to the following when installing the receiver:
1. "Make sure the receiver is not installed near motors or sources of electrical noise.
2. Keep the receivers antenna away from conductive materials such as carbon or metal. To ensure
normal function, make sure there is a gap of at least 1cm between the antenna and the conductive
material.
After setting up, follow the instructions below to operate the system.
Instructions
操作指引
Power On
开机
请按照以下步骤进行开机：
1. 检查系统状态，确保电池电量充足且安装正确。
2. 将电源开关拨到 [ON] 位置，R.LED 灯常亮。
3. 连接接收机电源。
• 为保障模型及人员安全，使用时请先打开发射机再给接收机上电
请请结合相应模型的结构选择合适的位置安装接收机， 同时为了确保接收机的性能和遥控距离的稳定，并
防止外界干扰，请注意以下操作事项：
1.确保接收机安装在远离电机，电子噪声过多的区域。
2. 接收机天线需远离导电材料 , 例如金属棒和碳纤物质。为了避免影响正常工作，请确保接收机和导电材料
之间至少有 1 厘米以上的距离。
准备操作完成后，您可以按照本章指引开始使用本产品。
Note Operate with caution in order to avoid damage or injury.
警告
此时系统已启动，请谨慎操作，否则可能导致产品损坏或人员伤亡。
Caution
To prevent damage do not power on the receiver during installation.
小心
准备过程中，请勿连接接收机电源，避免造成不必要的损失。
Note
Make sure that the throttle trigger is at its neutral position and the switches are set to their
proper position.
警告
为了您的安全请将发射机开关和油门打到安全位置。
To Next Page
Loading...
