EasyManuals Logo

FMT Swiss AG NUMERIxx3 Operating Instructions

FMT Swiss AG NUMERIxx3
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
G Operating instructions digital oval gear meter
2. General safety instructions
2.1 Information on safety at work
The oval gear meter has been designed and built in compliance with the applicable safety and health
requirements of the relevant EU directives.
However, hazards may result from this product if it is not used for its intended purpose or with the
necessary care.
In all cases, when operating the oval gear meter, local safety and accident prevention regulations apply,
as well as the safely instructions within these operating instructions.
2.2 Signs and symbols used in the safety instructions
Safety instructions within these operating instructions are indicated by the following keywords and
icons:
Pictogram Keyword Consequences of failure to comply with the safety
instructions
Caution Possible risk of slight to medium physical injury or material
damage
In addition, you will notice general information and tips for handling the product from time to time.
Pictogram Keyword Meaning
Tip Background information and tips on the right way of using the
product
2.3 Hazards that may arise in connection with the oval gear meter
Caution!
The oval gear meter has been designed and is suitable for operation with media of low
ammability, exclusively.
Do not operate this oval gear meter in areas with potentially explosive atmospheres.
Tip
Be sure to know and respect, in particular, any water management laws that may exist. In
Germany, for instance, § 19g of the German Water Management Act („WHG“) provides that
equipment for lling must be designed, constructed, installed, maintained and operated in such a
way that bodies of water are not aected in any critical ways.
The owner / operator of lling equipment is obliged to permanently check and manage any such
equipment for compliance with the afore-mentioned requirements at the place of installation.
3. Assembly
The oval gear meter comes fully assembled and ready to go.
There may be accessories that can or must be tted. This depends on the model you chose.
Tip
During assembly, make sure everything is perfectly clean. Take particular care that components
are well aligned and connected and t tightly.

Other manuals for FMT Swiss AG NUMERIxx3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FMT Swiss AG NUMERIxx3 and is the answer not in the manual?

FMT Swiss AG NUMERIxx3 Specifications

General IconGeneral
BrandFMT Swiss AG
ModelNUMERIxx3
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals