8
G Operating instructions digital oval gear meter
5.1 Output of liquid during standard operation (Normal Mode)
During standard output of liquid, the meter will count and at the same time display the volume having
gone through the device so far, and the resettable total (RESET TOTAL).
Accidental pressing of the RESET and/or CAL buttons does not have any eect in this state.
A few seconds after you‘re nished, the display of the lower register will change from resettable total to
absolute total: The word RESET above the word TOTAL will disappear, and the value of the resettable
total will be replaced by the absolute total.
We call this state (or mode) „standby“. It will persist as long as the user does not carry out any more actions
on the meter.
5.1.1 Resetting partial volumes
For resetting the partial volume register: Press the RESET
button while the meter is in standby, i.e. while you see the
word <<TOTAL>> in the LCD display.
When you press RESET, the display will rst switch on all the
segments, one after the other, and then switch them all o again.
When the reset is complete, the display will rst show the partial
volume having been reset and then RESET TOTAL.
After a couple of seconds, Reset Total will be replaced by the NON
resettable total volume (TOTAL).
To Next Page
Loading...
Need help?
General
