FMX TD400-2015-3PH - Page 4

Group 05 Preset Frequency Parameters 4-91
Group 06 Automatic Program Operation 4-95
Group 07 Start/Stop Parameters 4-99
Group 08 Protection Parameters 4-111
Group 09 Communication Parameters 4-120
Group 10 PID Parameters 4-121
Group 11 Auxiliary Parameters 4-130
Group 12 Monitoring Parameters 4-139
Group 13 Maintenance Parameters 4-142
Group 14 PLC Parameters 4-145
Group 15 PLC Monitoring Parameters 4-147
Group 16 LCD Function Group 4-148
Group 17 Automatic Tuning Parameters 4-152
Group 18 Slip Compensation Parameters 4-156
Group 20 Speed Control Parameters 4-159
Group 21 Torque Limit Parameters 4-163
Group 22 PM Motor Parameters 4-164
Chapter 5: Built-in PLC Function
5.1 Basic Command 5-1
5.2 Application Functions 5-3
5.2.1: Counter Function 5-3
5.2.2: Timer Function 5-5
5.2.3: Analog Comparator Function 5-8
5.2.4: Operation Control Function 5-9
5.2.5: Math Functions 5-10
Chapter 6: Communication
s
6.1 Modbus Protocol 6-2
6.1.1 Network Connection 6-2
6.1.2 Date Format Frame for ASCII Mode 6-3
6.1.3 Data Frame for RTU Mode 6-3
6.1.4 CRC 6-4
6.1.5 Register and Data Format 6-5
6.1.6 Monitor Data (Read-only) 6-6
6.1.7 Read holding Register [03H] 6-8
6.1.8 Loop Back Test [08H] 6-9
6.1.9 Write Single Holding Register [06H] 6-10
6.1.10 Write Multiple Holding Register [10H] 6-11
6.1.11 Modbus Addressing 6-12
6.2 BACnet Protocol Descriptions 6-20
6.2.1 BACnet Object Properties 6-21
Chapter 7: Troubleshooting, Fault Diagnostics and Maintenance
7.1 General 7-1
7.2 Fault Detection Function 7-1
7.3 General Troubleshooting 7-13
7.4 Troubleshooting Flowcharts 7-14
7.5 Routine and periodic inspection 7-20
7.6 Maintenance 7-22