Need help?Do you have a question about the FMX TD400-4002-3PH and is the answer not in the manual?
Details essential safety steps before applying power to the AC drive.
Provides critical safety instructions and warnings related to AC Drive wiring procedures.
Outlines crucial precautions and safety checks before operating the AC Drive.
Covers essential safety guidelines and warnings during AC Drive operation.
Provides safety warnings and procedures for maintenance, inspection, and component replacement.
Provides specifications for wire gauge, terminal torque, circuit protection, and fuse ratings based on AC Drive frame size.
Specifies environmental conditions required for proper AC Drive operation and longevity.
Provides guidelines for installing the AC Drive, ensuring adequate air circulation and heat dissipation.
Highlights important warning information located on the AC Drive's front cover for installation.
Provides crucial warnings and guidelines for wiring peripheral devices and power connections.
Presents a detailed wiring diagram for AC Drive control and power circuits, including terminal functions.
Explains the function and signal levels of control circuit terminals and the use of jumpers.
Details the power terminal configurations for AC Drive frames 1 and 2 (Three Phase).
Provides detailed wiring instructions for power input terminals and grounding.
Refers to wire size recommendations and requirements for disconnect or circuit protection.
Introduces the LED keypad, its display, and the functions of its keys for operation and programming.
Details the components of the LED keypad, including the display, indicators, and operational keys.
Explains how to navigate and monitor AC Drive parameters and functions using the keypad.
Covers parameters for setting up automatic operation modes, including frequency settings and timing for different stages.
Details parameters related to starting, stopping, and momentary power loss restart behavior.
Details parameters for stall prevention during acceleration, deceleration, and run.
Covers parameters for configuring communication settings like station address, mode, and baud rate.
Details parameters for PID control, including target value, feedback source, and control modes.
Covers parameters for automatic tuning modes, motor data input, and starting the tuning process.
Provides detailed explanations for basic parameters, including control mode selection and their functionalities.
Details multifunction input terminal settings for S1 through S6, covering various commands and functions.
Details parameters related to starting, stopping, and momentary power loss restart behavior.
Details parameters for stall prevention during acceleration, deceleration, and run.
Details parameters for PID control, including target value, feedback source, and control modes.
Explains how to interpret fault messages and lists possible causes and solutions for common faults.
Provides a table for general troubleshooting of common AC Drive issues like motor direction and speed.
Presents flowcharts for quick troubleshooting of AC Drive faults, including initial checks and potential solutions.
Guides troubleshooting for Overcurrent (OC) and Overload (OL) errors displayed by the AC Drive.
Provides troubleshooting steps for Overvoltage (OV) and Undervoltage (UV) conditions detected by the AC Drive.
Offers troubleshooting steps for diagnosing why the motor is not running, covering wiring and power checks.
Addresses troubleshooting steps for motor overheating issues, including load and cooling checks.
Guides troubleshooting for motor imbalance issues, including acceleration, output voltage, and vibration checks.
To Next Page
General
