FNS POWER FCIFP48100A - Battery Recovery; Transportation Requirements

23
service personnel of our company will reply the corresponding solution after receiving the data.
9. Battery recovery
Aluminum, copper, lithium, iron and other metal materials are recovered from discarded LiFePO4
batteries by advanced hydrometallurgical process, and the comprehensive recovery efficiency can
reach 80%. The specific process steps are as follows:
1. Recovery process and steps of cathode materials
Aluminum foil as collector is amphoteric metal. Firstly, it is dissolved in NaOH alkali solution to make
aluminum enter the solution in the form of NaAlO
2
. After filtration, the filtrate is neutralized with sulfuric
acid solution and precipitated to obtain Al (OH)
3
. When the pH value is above 9.0, most of the
aluminum precipitates, and the obtained Al (OH)
3
can reach the level of chemical purity after analysis.
The filter residue is dissolved with sulfuric acid and hydrogen peroxide, so that lithium iron phosphate
enters the solution in the form of Fe
2
(SO
4
)
3
and Li
2
SO
4
, and is separated from carbon black and
carbon coated on the surface of lithium iron phosphate. After filtration and separation, the pH value of
the filtrate is adjusted with NaOH and ammonia water. First, iron is precipitated with Fe (OH)
3
, and the
remaining solution is precipitated with saturated Na
2
CO
3
solution at 90 ℃.
Since FePO
4
is slightly dissolved in nitric acid, the filter residue is dissolved with nitric acid and
hydrogen peroxide, which directly precipitates FePO
4
, separates impurities such as carbon black from
acid solution, leaches Fe (OH)
3
from filter residue respectively, and precipitates Li
2
CO
3
with saturated
Na
2
CO
3
solution at 90
℃
.
2. Recovery of anode materials
The recovery process of anode materials is relatively simple. After the separation of anode plates, the
purity of copper can be more than 99%, which can be used for further refining electrolytic copper.
3. Recovery of diaphragm
The diaphragm material is mainly harmless, and has no recycling value.
4. List of recycling equipment:
Automatic dismantling machine, pulverizer, wet gold pool, etc.
10. Transportation Requirements
The battery products should be transported after packaging and during the transportation process,