5
2.3 State Indicator
Table 2-2: Unprotected fault working mode
Note: Flash: Light 0.5s, No light 0.5s
Table 2-3: Protected fault working mode
When the BMS detects a protection fault, the RUN indicator flashes from on for 0.5s to off for 0.5s, to
off for 0.5s and then on, waits for the ALM indicator to turn off for 0.5s after flashing according to the
fault, and repeats this cycle.
No light 0.5s
and always
Light
Table 2-4: Fault code
RUN always Light and
ALM flashes
RUN always Light and
ALM flashes
To Next Page
Loading...