FoamPRO 2001 Series User Manual

1
INSTALLATION AND
OPERATION MANUAL
Form 829
6/16
All quality FoamPro products are ruggedly designed, accurately machined, carefully assembled, thoroughly inspected
and tested. In order to maintain the high quality of your unit, and to keep it in a ready condition, it is important to follow
the instructions on care and operation. Proper use and good preventive maintenance will lengthen the life of your unit.
ALWAYS INCLUDE THE UNIT SERIAL NUMBER IN CORRESPONDENCE.
Unit
Serial
Number
Systems 2001, 2002,
2002HP and 2024
FoamPro • 26 Southern Blvd. • Nesconset, NY 11767 USA • 800-533-9511 • FAX 816-892-3178

FoamPRO 2001 Series Specifications

General

Brand	FoamPRO
Model	2001 Series
Category	Measuring Instruments
Language	English

Summary

1 Safety Precautions

2 System Overview and Components

4 Installer Supplied Parts

5 Installation Planning

6 Plumbing Installation

Foam Pump/Motor Base and Relief Valve Installation

Details mounting the pump base and installing the discharge relief valve.

CAL/INJECT Valve, Strainer, and Flowmeter Installation

Instructions for installing CAL/INJECT valve, line strainer, and flowmeters.

Injector Fitting, Check Valves, Drain Lines, and Flushing

Covers injector fitting, check valves, drain lines, and system flushing procedures.

7 Electrical System Installation

Electrical Connections and Power Supply

Guidelines for electrical connections, DC motor power, and overall power supply.

System Protection and Wiring Practices

Information on solid state contactors, EMI/RFI suppression, and cable management.

8 System Verification and Operation

System Power and Priming Checks

Procedures to verify system power, pump operation, and foam priming.

Normal Operation and Display Functions

Guide to normal system operation, display functions, and messages.

Simulated Flow Operation

Guide to using the simulated flow function for manual control and testing.

9 Calibration and Setup

System Setup and Reset Procedures

Configuring dual-tank/remote operation and system reset procedures.

Calibration Procedures

Steps for calibrating flowmeters, injection rate, and the foam pump.

10 Maintenance and Troubleshooting

Maintenance Schedule

Recommended monthly and annual maintenance tasks for the FoamPro system.

Troubleshooting and Diagnostic Mode

Guide to diagnosing problems and using the system's diagnostic mode.

Parts Identification

Installation Drawings

Flowmeter Specifications

Notes

15 Limited Warranty