Need help?Do you have a question about the Focus Paralane and is the answer not in the manual?
General| Fork | Carbon |
|---|---|
| Brakes | Disc |
| Wheel Size | 700c |
| Drivetrain | Shimano 105 |
| Shifters | Shimano 105 |
| Rear Derailleur | Shimano 105 |
| Front Derailleur | Shimano 105 |
| Crankset | Shimano 105 |
| Cassette | Shimano 105 |
| Frame Material | Carbon |
Instructions for placing the front fender, washer, and M5x10 screw, followed by tightening.
Procedure to loosen the M4 screw, insert the fender stay, and retighten the screw.
Steps for inserting M5 nuts and washers and tightening them to secure the fender and stay.
Guides for inserting the main (370mm) and auxiliary (340mm) fender stays through the stay clips.
Instructions for inserting M4x10 screws and M4 nuts into stay clips to secure both fender stays.
Steps for inserting the bridge hook onto the fender and sliding it into the correct position.
Procedure to place the bridge and hook, adjust width, and secure with M5x30 screws, washers, and M5 nuts.
Final steps for securing main and auxiliary stays with M5 nuts and washers using an 8mm wrench.
Instructions for placing the fender and inserting M5x10 screw and washer, then tightening.
To Next Page
