10
When mixing, you can connect an additional pair of speakers (mid-field. near-field, etc.) to
LINE OUTPUTS 3 and 4 to check your mix on different types of speaker. You can easily configure
Focusrite Control to route the mix to these outputs as well as Outputs 1 and 2.
Main
Monitor
Speakers
Additional
Monitor
Speakers
IMPORTANT:
LINE OUTPUTS 1 and 2 incorporate “anti-thump” circuitry that protects your speakers
if the Clarett 4Pre is turned on while the speakers (and amplifier if used) are connected
and active.
LINE OUTPUTS 3 and 4 do not have this circuitry.
If you’re using additional speakers connected to these outputs, we recommend that you
power your Clarett 4Pre on first,
then
turn on the speakers or power amplifier. But get
into the habit of following the general rule in any case - it is
always
good audio practice
to turn on a speaker system of any kind
after
turning on the equipment feeding it.
To Next Page
Loading...
Need help?
General
