Need help?Do you have a question about the Focusrite Red 7 and is the answer not in the manual?
Details the identical controls for each of the four channels on the Red 1.
Explains how to match incoming level and gain using the meter and gain control.
Guides on using the phase switch to ensure correct signal phasing with multiple microphones.
Provides instructions for recording in stereo using matched microphone pairs.
Defines compressor and limiter functions and explains dynamic range.
Details the ratio, threshold, attack, and release controls for the compressor.
Explains how to set the ratio and threshold for effective signal compression.
Guides on setting attack and release rates for compressor response.
Describes using make-up gain to restore signal volume after compression.
Explains gain change metering and using the key input for side-chain compression.
Covers stereo compression, compensating for quiet signals, and usage guidelines.
Details mic preamplifier features, gain controls, and input switching.
Refers to the Red 3 compressor section for detailed usage information.
Explains the de-esser for sibilance removal and the exciter for frequency amplification.
Describes the high-pass filter for removing rumble and bass lift.
Describes the Red 8 as providing two independent microphone preamplifiers.
Provides diagnostic steps for units with no LEDs or partial LED illumination.
Detailed safety instructions for changing fuses in Red modules.
To Next Page
General