26
Monitor control enable buttons (1 to 6)
The Monitor control enable buttons select which outputs are controlled by the mixer’s monitor section, immediately below.
The Saffire PRO 26 can be set up so that you have hands-on control of volume levels, and depending on your monitoring setup, you
can control no speakers, just a single pair of speakers, or up to 6 speakers simultaneously.
Note that the S/PDIF digital output level is unaffected by Saffire MixControl. Use the output level controls in the DAW to control
signals sent to this output.
Each button can be set to 1 of 3 possible states:
Blue - this output is controlled by the Saffire MixControl monitor section.
Red - this output is muted and not controlled by the Saffire MixControl monitor section.
Grey - this output is fixed at full level, and is not controlled by the Saffire MixControl monitor section. To set a button to this
state, use SHIFT + Click.
WARNING: When a Monitor control button is set to ‘Grey’, the signal routed to that output will be played
back at full level. This may potentially result in a very loud level being reproduced by your monitor
speakers, headphones or other equipment. Be cautious when setting your levels (in your DAW or the
Saffire MixControl Mixer) before setting the monitor button to Grey.
Monitor Presets
These presets allow quick selection of typical monitoring set-ups.
Note that for the monitor presets to work correctly, you must have your speakers connected to the line outputs as shown below.
To Next Page