Page 5 of 15 ENG 0019.14 Part # 93030
The unit is supported (hung) by the trim on the top side edges resting on the countertop.
Secure the unit into position by screwing the stove sides to the walls of the cut out. The
mounting holes are located inside the front and back vent holes on both sides of the top
tray. (To access the holes remove the top tray). Use #8, 1” stainless steel wood screws.
(Screws not included) Attach gas line to the back of the unit before securing into place.
For additional ventilation and heat dispersion, it is recommended that you have (2) or (3)
1” (25mm) diameter holes on each side of the bottom of the cutout.
OPERATION
Features
Your Force 10 Gourmet Galley Range has a number of features to make your unit easier
to use.
Electronic Spark Ignition – Your unit is equipped with an electronic spark ignition
system. The system is powered by a 1.5V AA battery. The spark system may either be
initiated by a separate ignition button or may be integrated into the valve.
Pot Holders - There are (2) sets of Pot holders included with your unit. These Pot
holders are designed to hold pots in place during movement. To install the pot holder,
screw the unit (clockwise) into the black base on either side of the top grill. Adjust the
width of the arms by loosening the black knob (counter-clockwise) and separating the
arms to the desired width.
Slide-Away Oven door - Your Force 10 Range is equipped with a slide away space
saving door. To open the door, lift up on the handle and pull towards you. The door will
fold underneath the oven.
The door has two positions; fully closed and broiler position. The broiler position uses
the set of notches on the end of the handle arms. There is also a door lock that should be
used when the oven is not in operation.
To lock the handle, lift up the brass knob located on the right side of the handle and slide
it towards the door. To unlock the handle lift up the knob and slide it towards the handle.
Removable Top Grill - This range is equipped with a removable top grill for ease of
cleaning and maintenance.
To remove:
Rotate the two clasps located on each end of the grill frame up ward
approximately 45 degrees until the clasp disengages the spool. (The clasp when
properly engaged will ride in the center slot of the round spool that is attach to the
stove) Once the clasps are disengaged lift the rear of the grill and at the same time
pull it towards the front of the stove. This motion will allow the small hook
sections of the grill frame to ride over the top of the spool. The grill frame will
now be free of the stove.
To Next Page
Loading...