Installation (Steel Track)
Figure 3
STEP1 (Fig.3)
Attach the opener head to the steel track. Assembly the 2 “U” Hanging brack ets
with 6mm nuts supplied.
STEP2 (Fig.3)
Place the steel track and opener head assembly centrally on the garage floor, with
the open head furthest away from the door. Lift the front of the track up to the door
bracket. Insert the pivot pin and secure it with the split pin supplied.
STEP3 (Fig.3, Fig.4)
Lift and support the opener head (with a ladder) so it is
positioned centrally and level. Fix the opener and track
on ceiling by Iron bracket A & B.
WARNING: Do not allow children around the door,
opener or supporting ladder serious injury and/or
damage may result from failure to follow this warning.
STEP4 (Fig.3, Fig.5)
Fix the shuttle to assembled by 4pcs 6x23 screws, and
then slide the shuttle towards the closed garage door.
Select and attach the straight arm and bend arm.
Position and bolt the arms to the top edge of the door
using the bolts supplied.
STEP5
Lift the garage door until the shuttle locks into the
drive chain/belt.
Now, ready to program the openers.
To Next Page
Loading...
Need help?
General
