ForceDoor BASE 35 - Page 9

7
4. Long press：
/
Long press the button UP/DOWN to set the door to the target OPEN limit position,
then release the buttons.
Short Press the SET button once to store the open limit position, the digital displays
to start the CLOSE travel limit setting.
5. Long press：
/
Long press the button UP/DOWN to set the door to the target CLOSE limit position
then release the buttons.
Short press the SET button once to store the CLOSE limit position, then the door
drive will automatically open and close the door to store the door weight and
spring balance conditions.
Note:
a. If a system selection error occurs during the setting process, please
click ，Execute enter to exit the setting, and then execute the first
operation again.
b. Active or change any stand alone function, refer to the below
"FUNCTION TABLE MENU".