Next Generation Firewall Hardware Guide | Models N120W, N120WL,and N120L
Steps
1) Connect to the NGFW Engine command line.
Depending on the appliance type, use one of the following options:
■
Connect a computer running a terminal emulator program to the appliance console port, then press
Enter.
■
Connect using SSH.
Note
SSH access is not enabled by default.
■
Connect a keyboard to a USB port and a monitor to the VGA port, then press Enter.
2) Enter the logon credentials.
The user name is root and the password is the one you set for the appliance.
3) Enter the following command:
halt
4) Wait until the power indicator light turns red or is unlit, then unplug all power cables from the appliance.
Replace the SIM card for models N120WL and
N120L
You might need to replace the SIM card for the LTE modem in the models N120WL and N120L if you change
mobile operators, or if you get a new SIM card from the same mobile operator.
Before you begin
Before you insert or replace a SIM card, turn off the appliance.
The SIM card must be a Nano-SIM card. Full-sized SIM cards, Mini-SIM cards, and Micro-SIM cards are not
supported.
Steps
1) To release the SIM card tray, gently push the SIM card tray.
2) Remove the SIM card tray.
3) Remove the old SIM card from the tray.
4) With the SIM card contacts facing down, insert the SMC card into the tray, then gently push the tray back into
the SIM card slot.
5) Press the power button to start up the appliance.
22
To Next Page
Loading...
