Next Generation Firewall Hardware Guide | Models N120W, N120WL,and N120L
6) If PIN code query is enabled on the new SIM card and the modem interface is used for the management
connection, change the PIN code.
Note
If the PIN code for the new SIM card is the same as the PIN code for the old SIM card, it is not
necessary to change the PIN code.
a) Log on to the appliance.
The user name is root and the password is the one you set for the appliance.
b) To start the NGFW Configuration Wizard, enter the following command:
sg-reconfigure
c) In the NGFW Configuration Wizard, enter the PIN code.
d) To restart the appliance, enter the following command:
reboot
e) In the Management Client, enter the PIN code in the modem interface properties, then refresh the policy
on the NGFW Engine.
Note
Tasks in the Management Client are intended to be done by the SMC administrator.
Compliance information
Forcepoint NGFW appliances that have wireless support are in compliance with certain EU directives and FCC
standards for wireless devices intended for home and office use.
This information is valid for all dual band products (2.4 GHz, IEEE 802.11b/g/n, and 5 GHz, IEEE 802.11a/n/ac).
The supported channels and frequencies are listed by country in the Management Client. The wireless
configuration is transferred to the appliance when you install the policy on the NGFW Engine.
EU Directives
This appliance is in compliance with:
■
EMC directive 2014/30/EU
■
LVD directive 2014/35/EU
■
RED directive 2014/53/EU
The frequencies and maximum transmitted power in the EU are:
■
2.41–2.47 GHz: 15.75 dBm (EIRP)
23
To Next Page
Loading...
