Maintenance
and care
242
4. On the wall or screen you will
observe an area of high intensity
light. The top of the high intensity
area should touch the horizontal
reference line, if not, the beam will
need to be adjusted.
5. Locate the vertical adjuster on
each headlamp, usinga7mmAllen
head wrench, turn the adjuster
either clockwise (to adjust down)
or counterclockwise (to adjust up),
the high intensity area should
touch the horizontal reference line.
6. HORIZONTAL AIM IS NOT
REQUIRED FOR THIS VEHICLE
AND IS NONĆADJUSTABLE.
7. Close the hood and turn off the
lamps.
To Next Page
Loading...
