Condition Potential Causes
No MyKey™
function
• An admin intelligent access key is present at a
push-and-start vehicle.
• No MyKeys™ are programmed to the vehicle.
Refer to Create a MyKey™ section.
• Vehicle has been started using a non
Ford-approved remote start system (as an admin
key) then a MyKey™ is inserted without restarting
the engine.
MyKey™
programmed total
includes one
additional key
• Unknown key has been programmed to the vehicle
as a MyKey™.
• Vehicle is equipped with a non Ford-approved
remote start system. Refer to Using MyKey™ with
remote start systems section.
Admin keys
programmed total
includes one
additional key
• Unknown key has been programmed to the vehicle
as admin key.
• Vehicle is equipped with a non Ford-approved
remote start system. Refer to Using MyKey™ with
remote start systems section.
MyKey™ distance
does not
accumulate
• MyKey™ is not being used by the intended user.
• MyKey™ system has been recently cleared.
• Vehicles has been remote started using a non
Ford-approved remote start system (as if an admin
key) then a MyKey™ is inserted without recycling
the MyKey™ in ignition.
Locks and Security
137
2011 Explorer (exp)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
