Perform the following steps to attach a child safety seat to the tether
anchor:
1. Route the tether strap:
• Second row outboard seat positions: route the child safety seat
tether strap over the seatback, under the head restraint and between
the head restraint posts. If needed the head restraint can be removed
to improve the fit of the child safety seat or tether strap.
• Second row center seat positions: lift the head restraint to the full
up position. Route the child safety seat tether strap over the seatback,
under the head restraint and between the head restraint posts. If
needed the head restraint can be removed to improve the fit of the
child safety seat or tether strap. See Rear seats in this chapter for
head restraint information.
• Third row seat position: route the child safety seat tether strap
over the seatback, under the head restraint and between the head
restraint posts. If needed, the head restraint may be folded down to
improve the fit of the child safety seat or tether strap. See Rear seats
in this chapter for head restraint information.
2. Locate the correct anchor for the selected rear seating position:
• 2nd row bucket (40/40)
Seating and Safety Restraints
220
2012 Explorer (exp)
Owners Guide, 2nd Printing
USA (fus)
To Next Page
Loading...
