BLIND SPOT INFORMATION SYSTEM (BLIS姞) WITH CROSS
TRAFFIC ALERT (CTA) (IF EQUIPPED)
The BLIS威 is a convenience feature
that aids the driver in assessing
whether a vehicle is within an area
on either side of the vehicle
extending rearward from the outside
mirrors to approximately 10 feet
(3 meters) beyond the bumper. This
area is referred to as the blind zone.
The BLIS威 will alert the driver to
the presence of motorized vehicles
in these areas while driving on roads
and freeways.
The system is not designed to
prevent contact with other vehicles
or objects. The system is designed
to provide a warning to assist the
driver in detecting vehicles in the blind zones. The system will not detect
infrastructure, pedestrians, or cyclists.
WARNING: To help avoid injuries, NEVER use the BLIS威 as a
replacement for using the side and rear view mirrors and looking
over your shoulder before changing lanes. BLIS威 is not a replacement
for careful driving and only an assist.
The BLIS威 and CTA has a yellow
indicator (also referred to as the
alert) located in the left and right
exterior mirrors. When the vehicle is
started, the BLIS威 automatically
illuminates both indicators for
several seconds indicating the
system is operating. The first time
you place the transmission in D (Drive) after starting the engine and
drive forward at a speed greater than 3 mph (5 km/h) the BLIS威 system
becomes active. Afterwards, the BLIS威 remains active for all speeds
including zero mph. BLIS威 is also active if the transmission is placed in N
(Neutral). If the transmission is shifted out of D (Drive) or N (Neutral)
the system will enter the CTA mode (see CTA operation below). Once
shifted back into D (Drive) the BLIS威 mode will activate once driven
above 3 mph (5 km/h).
Driving
305
2012 Explorer (exp)
Owners Guide, 2nd Printing
USA (fus)
To Next Page
Loading...
Need help?
General
