Removing the Spare Tire
1. To remove the spare tire, remove the
jack handle from the right side
compartment, open the rear doors and
remove the thumb screw and anti-theft
bracket. If finger pressure will not
remove the thumb screw, use the lug
nut wrench tip to loosen it.
2. Remove the access cover from the
rubber strip. Guide the lug wrench or
jack handle through the hole and into
the tube.
3. Turn the wrench or handle
counterclockwise until the cable has
slack and the tire can be slid rearward.
4. Remove the retainer from the spare tire
and remove the spare tire.
5. Use the lug nut wrench to remove the
wheel trim, if equipped.
6. Loosen each wheel lug nut one-half
turn counterclockwise. Do not remove
them until the wheel is raised off the
ground.
7. For E-350 dual wheel and E-450
equipped with hydraulic jacks, two
handle extensions are used to operate
the jack. To assemble, align the button
with the hole and slide the parts
together. To disconnect, press the
button and pull apart.
Jacking the Vehicle
Position the jack under the correct jacking
points according to following pictures.
219
2023 E-Series (TE4) Canada/United States of America, enUSA, Edition date: 202111, First-Printing
Wheels and Tires
To Next Page
Loading...
Need help?
General
