2. Release the button.
3. Press the button with short presses
(less than two seconds) several times
until the desired speed appears in the
display.
4. To save, wait five seconds on this
screen or press the button for at least
two seconds. You will hear a beep and
the display will stop blinking indicating
that your selection has been saved.
This step must be followed for all three
sections (OFF to ON, ON to OFF and
ON to ON) that describes the speed
alarm save process.
Note: The maximum selectable speed for
the alarm is 140 km/h. If you continue to
press the reset button with short presses
the display will go back to the OFF mode
and so the multiples of 10 speeds will be
displayed again.
Note: In set mode, the selectable speed
displayed after the OFF screen will always
be the next multiple of 10 in speed from the
speedometer (i.e. if your speedometer
indicates 63 km/h, the speed alarm will give
you option from 70 to 140 km/h. If
speedometer indicates 100 km/h, the speed
alarm will give you options from 110 to 140
km/h. If speedometer indicates 30 km/h,
the options will be from 40 to 140 km/h).
The process to switch the speed alarm Off.
From:
1. Press the reset button with a long press
(for at least two seconds) until the
display of the speed alarm symbol and
the speed unit begins to blink. This
indicates that the screen is now in edit
mode.
2. Release the button.
3. Press the button with a short press
(less than two seconds) once, the
display will change to OFF.
4. To save this speed, wait five seconds
on this screen or press the button after
at least two seconds. You will hear a
beep and the display will stop blinking
indicating that your selection has been
saved.
The process to set a new speed when the
speed alarm is active.
From:
To Next Page
Loading...
