168
Roadside emergencies
•
Turn the bulb holder
anticlockwise as far as possible and
pull it out.
Gently press the bulb into the
bulb holder and turn anticlockwise.
Remove and replace the bulb.
Install in the reverse order.
After installation, check that the
lights operate correctly.
Reversing light
•
Press up the clip on the rear of
the light housing and press the
housing to the outside. Disconnect
the wiring connector.
Turn the bulb holder
anticlockwise as far as it will go and
pull it out.
Gently press the bulb into the
bulb holder and turn anticlockwise.
Remove and replace the bulb.
Install in the reverse order.
After installation, check that the
lights operate correctly.
•
•
•
•
•
•
•
To Next Page
