KEYLESS ENTRY KEYPAD
The keypad is near the driver window and illuminates
when touched. The keypad allows you to lock or unlock
the doors and frunk. You can operate the keypad with the
factory-set, five-digit entry code found on the owner’s
wallet card in the glove compartment or by using your
personal code. You must press each number within five
seconds of each other.
TO UNLOCK ALL DOORS
Enter the factory-set code or your personal code, then
press 3·4 within five seconds.
TO LOCK ALL DOORS
Press and hold 7·8 and 9·0 at the same time with the
driver door closed. You do not need to enter the keypad
code first. See the Doors and Locks chapter in your
Owner’s Manual for more information.
TO OPEN THE FRUNK
Enter the factory-set code or your personal code, then
press 7-8 on the keypad within five seconds.
CONVENIENCE
REMOTE CONTROL ICONS
Press once to lock all doors. One short flash
of the turn signal lamps confirms that your
vehicle has locked.
Press once to unlock all doors.
Press the button to sound the panic alarm.
Press the button again or switch your vehicle
on to switch the alarm o.
NOTE: The panic alarm only operates when your
vehicle is o.
Press the lock button twice within three
seconds. The turn signal lamps flash. We
recommend you use this method to
locate your vehicle.
Press twice to open the ligate.
MYKEY™
MyKey allows you to program keys and mobile
devices with restricted driving modes to promote
good driving habits.
Refer to the MyKey
TM
chapter in your Owner's
Manual for more information.
13
To Next Page
Loading...
Need help?
General
