EasyManua.ls Logo

Foreo PEACH 2 - How to Use PEACH 2; Device Setup and Preparation; Device Operation

Foreo PEACH 2
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
HOW TO USE
WARNING: Follow each step in the treatment process ensuring you complete
all aspects of each step before progressing to the next.
UNLOCK YOUR DEVICE
Download the FOREO app to unlock & register your PEACH
2 before first
use. You can do this by scanning the QR code which can be found on the back
of the device packaging, or on the Quick Start Guide that comes with your
device.
PREPARE THE TREATMENT AREA
Remove any visible hair on the skin before using the device. We recommend
shaving body hair and dermaplaning facial hair, for optimal results. Make sure
there is no hair remaining above the surface of the skin as this may cause injury.
This also prevents debris from covering the front of your device. Clean the
treatment area and pat it dry.
TURN ON THE DEVICE
Attach the relevant plug adaptor to the power cable. Then use the power
cable to connect the device to an electrical outlet. The device will turn on
automatically. You can adjust to your preferred intensity level using the + and -
buttons.
NOTE: Levels 1 - 3 on your device are intended for sensitive areas and first
time users. With reduced light intensity, more treatments may be required to
see the desired effects. As long as the treatment feels comfortable, increase
the setting by one level within the recommended intensity range for your skin
type.
PATCH TEST
Before your first treatment on each new body area, we RECOMMEND you test
your skin in that area for a reaction to the device. The patch test area should
be approximately 3cm x 3cm in size (equivalent to 1 flash from PEACH
2 ).
Perform the patch test as described below in the ‘Treatment Methods’ section,
under ‘Stamp Mode’. Wait 24 hours following the patch test, to ensure your
skin is suitable for treatment and there is no adverse reaction to the light
energy. If there is no reaction after 24 hours, you may treat the area around
the patch test. The ‘patch tested area’ should NOT be re-treated for at least 2
weeks. If a skin reaction develops, discontinue using the device and consult
your physician.

Other manuals for Foreo PEACH 2