9
TREATMENT METHODS
The area to be treated must be hair-free, clean and dry. Before pushing the flash
button, look away from the device to avoid the bright light. In rare cases, you
may find the flash too bright. There is no safety risk associated with this. For
increased comfort, we recommend treating in a well-lit room to help reduce
the perceived brightness. However, if you find the light is still too bright, we
recommend wearing sunglasses for extra eye protection. We also recommend
wearing sunglasses for extra eye protection when using the device to remove
hair on the face.
GLIDE MODE
For fast & efficient treatment of large areas - like the legs, arms, chest, back
& stomach
1. Place the treatment window firmly on your skin, and select your preferred
intensity level.
2. Press and hold the flash button. The device will begin to flash.
3. Glide the device slowly and continuously from the bottom to the top of the
treatment area. Make sure to always keep full skin contact so that the device
flashes continuously.
4. Once the gliding stroke is complete, lift the device off the treatment
area.
5. Repeat to treat the next adjacent area in a parallel glide, until you have
completed the entire area you wish to treat.
STAMP MODE
For treating small or hard-to-reach areas - like the face, bikini line &
underarms
1. Place the treatment window firmly on your skin, and select your preferred
intensity level.
2. Press and instantly release the flash button. The device will emit a flash.
3. Lift the device off the skin, and place it onto the next adjacent spot to be
treated.
4. Continue treatment spot by spot, until you have completed the entire area
you wish to treat.
NOTE:
• The treatment window on your PEACH
™
2 must be in full contact with your
skin, or the flash won’t work.
To Next Page
Loading...
