Forest PERGOLA CANOPY - Position and Secure 1 X Hook Receiver to each Corner of the Slotted Rafters; Position 1 X Hook Receiver in the Centre of the Front Slotted Rafter; Unscrew All of the Bottle Screws of Which Are at the Ends of each Wire Supplied

Position and secure 1 x Hook Receiver to each corner
of the slotted rafters, approximately 20mm away
from the upright posts. Ensure the Hook Receiver is
near to the bottom of the rafter, as shown above.
11
22
Once positioned, secure each Hook Receiver using
4 x 40mm screws.
Tighten the Wires using the middle section of each
Bottle Screw. If necessary, use a spanner to ensure
the Wires are properly taught, as shown above.
77 88
Position and secure 1 x Large Roller on the side
of the pergola, above the Hook Receiver. Use 2 x
40mm screws for each. Repeat the process on the
other post, where the other end of the Wire nishes.
Position 1 x Hook Receiver in the centre of the front
slotted rafter. Ensure it is central and positioned
towards the rafter above. Repeat the process on the
back slotted rafter.
33 44
Once positioned, secure them using 4 x 40mm
screws.
Unscrew all of the Bottle Screws of which are at the
ends of each Wire supplied, as shown above.
55 66
Using the Bottle Screws, hook the Wires to the
Hook Receivers. Ensure you hook the Wires to the
adjacent Hook Receivers, and not to the Receivers
on the same rafter.
KIT CONTAINS (UPK02CKP)