Forest PERGOLA CANOPY - The Canvas Has Plastic Clips Along Its Edges and in the Centre; Take the Plastic Clips from the Middle of the Canvas and Start from the Back; Fold out the Canvas and Hook the Remaining Clips Along the Middle Wire; The Pole Sections for this Canopy Comes in 2 Parts

The front of the Canvas has 2 x rounded cutouts and
the back has eyelets for screwing into the rafter. For
reference, see the above.
1818
The Canvas has plastic clips along its edges and in
the centre. Ensure the clips in the middle are on the
top side of the Canvas.
All of the plastic clips will be hooked onto the
middle Wire as shown above.
2222
2323
Repeat the process for all of the remaining plastic
clips on both edges of the Canvas, as show above.
Take the plastic clips from the middle of the Canvas
and start from the back. Place the clip around the
middle Wire and twist it to hook it on.
1919 2020
The plastic clip when secured will look like the
above.
Fold out the Canvas and hook the remaining clips
along the middle Wire.
2121
1717
The Pole Sections for this canopy comes in 2 parts.
They will need to be connected together when
inside the Canvas.
2424
Front Back