Forest PERGOLA CANOPY - Position 1 X Small Roller Centrally under the First Rafter Inwards from each Upright Post; Once Secured, Take 1 X Long Rope and Thread One End through the Small Roller; Ensure the Long Rope Goes over the Top of the Middle Wire; Repeat the Process for the Front and Back of the Pergola

Position 1 x Small Roller centrally under the rst
rafter inwards from each upright post. Secure using
2 x 35mm screws each.
99
1010
Once secured, take 1 x Long Rope and thread one
end through the Small Roller furthest away from
Large Roller. If necessary use a nger to feed the
rope through the Roller.
Thread the Small Rope through the top of the Large
Roller and pull it through the bottom. Ensure the
other end of the rope does not leave the Small
Roller.
1515 1616
Using the two ends of the ropes that have been
threaded through the Large Roller, tie them in a knot
as shown above.
Ensure the Long Rope goes over the top of the
middle Wire, as shown above.
1111 1212
Thread the Long Rope through the top of the Large
Roller and pull it through the bottom. Ensure the
other end of the rope does not leave the Small
Roller.
Repeat the process for the front and back of the
Pergola. Ensure it looks like the above.
1313 1414
Using the 1 x Small Rope, thread one end through
the Small Roller closest to the Large Roller on the
front of the pergola. Repeat this on the back.